Keeping track of the current market growth, we are manufacturing and supplying an intricately engineered range of Solar AC Pump Controller. Offered in numerous technical specifications in synchronization with the application requirements of our respected clients, this controller comes with highly latest IGBT technology for high-tech micro-controller and Power conversion. In addition, it features inbuilt MPPT controller to control pump frequency in accordance with solar radiation for acquiring maximum power from solar panel.
Features of Solar AC Water Pumping System: Intelligent v/f control method to manage AC pump with constant water flow output as per solar radiation
Dual mode of operation solar or grid
Water pumped even in morning, evening and in cloudy weather
It can easily match with all kinds of ac submersible pumps
Suitable for different environment with low maintenance cost
Max. Operation temperature is 550 C
It uses minimum system component with maximum output compare to conventional controller
Inbuilt MPPT tracking facility to get maximum power from solar array
Transformer less design so Light weight and easily transportable
Higher efficiency with long life
Natural air cooling with high efficient anodized heat sink
New design
Automatic trip on fault
Durable and highly reliable
IP20 or IP65 Enclosure (Waterproof) as per customer requirement
Irrigation possible at Remote locations
Environment friendly operations
Conventional grid electricity can be use at night for Irrigation
Highly reliable and durable
Eco-friendly (Zero Noise Pollution -Zero CO2 Emission)
No fuel Required
Almost no maintenance required
Provide consistent water
Over voltage and under voltage protection
Over load protection
Sensor less Dry running protection
Reverse polarity protection
Phase imbalance protection
short circuit protection
Low radiation protection(if solar radiation is not so high to lift water from bore well then controller will give low radiation error and restart after half an hour)
The controller will restart automatically on every half an hour in the faults of dry running, under voltage error but it will not restart automatically in the faults like Over load and phase imbalance
Input DC Voltage
Motor current
Motor frequency
Motor Run or Stop status
All faults
There are 3 LEDs on controller door one for displaying status of motor run or stop second for power and third for fault.
